ENOMAKER X1,X1C Hardened Steel Hotend Kit for Bamboo Lab X1 Carbon 3D Printer,Heating Block Replacement,High Speed,High Temp Extruder Hot End,with 0.2,0.4,0.6,0.8mm Nozzle,Thermistor,Ceramic Heater

Great value overall. It printed well right after install. Haven't had an issue yet. Don't forget to tighten the nozzle while it's hot before you start your first print.

Good quality - kit is complete - very easy to exchange nozzles

These are what should have come with stock bambu x1c Prints great Far more serviceable than the stock hotends being able to change nozzle size this way is how every other printer I have had does it

It works ok with 0.4/0.6 nozzles, but become completely useless with the 0.2. The problem here is that the filament channel does not end up on the top of radiator like it made in original Bambu's hotend so when cutter cuts the filament it just skews and blocks/clogs the channel.

Super simple to swap the nozzle Tighten the tip before running my benchy Works perfect 👌 100% Recommend

This prints as well as a stock hotend, although I have not done a flow test yet. Swapping the nozzles is relatively easy. My complaints are that a screw had not been installed, and there are no instructions. You need to remove the throat and put some thermal paste on it and reassemble everything. Not sure how the average person, who doesn’t have experience building hotends, would know that. Even just a little note to remind them would be good. You risk having thermal creep and getting a bad reputation for your hotend. All in all, I’m happy with the purchase and have enjoyed trying the different nozzles.

If you have problems, trying to get the nonsense off, hook it up to your printer and preheat it heat expands the metal as it cools it shrinks this is how you get the nozzle off

If you are like me and have a X1C or similar you know that it is a hassle to have to swap out hot ends for just a nozzle change. The wires are somewhat easy to come out of the connectors and you take your chances disconnecting and plugging in the connector to the surface mounted receptacles cause they can break off the board. Not anymore. One hot end is all you need to change the nozzle from .2, .4, .6, and .8mm. It is very easy to assemble and it comes with the heater cartridge and the thermistor. It even comes with a nice little box to hold everything in and thermal grease with wrenches. A must have and you will not regret it.