Extreme Max 3005.2187 Transom Saver - Rubber V-Block Only, Black

Did not fit exactly as it said it was a replacement for the one I had. But I liked the fact the the dimensions were given. I thought it would fit but did not. I was able however to glue a piece of hardwood to the back of it and insert into the transom. Fits perfect and tight. I see no issue using this as intended.

I used this on top of my front gunnel to hold my 6' front transducer pole, while moving. The bracket is great, very sturdy, very easy to install. For my application, I drilled a 3/8" hole through the V center. Then used a S.Steel bolt, with backing plate for strength. There's no weight being applied, just anal about support. This bow bracket is very narrow, perfect for my use, but not for any regular size bow. This is roughly 2.25" across the V, and about 2.5" deep. It's tough rubber, not flexible at all. Hope this helps anyone looking at this little bugger.

The rubber piece in my transom saver for my Lund Fisherman 1800 was so worn out that the bolt going through the rubber piece was putting chips and nicks in my skeg or lower unit (not good) so i thought I would try this one, measured exactly the same and fit in there perfectly, really snug and tight. Going to work really good. Glad I saw that the rubber I had on there was dinging my lower unit before it got too bad, glad I found this one on Amazon for the right price!

Fit great! Works better than the factory one!

It's better than the broken one!!

I really liked this to replace my original tracker marine version which after years of use was cracking and splitting. This version is made of very dense rubber and should last for years. Installation was a breeze and did not require any modification except to widen the gap just a bit on the transom saver arm. Would recommend to others needing to replace theirs.

The part fit my Mercury outboard perfectly and is made of a firm enough rubber that it holds its shape when put into service.

I have a 60 hp Mercury motor, and the rubber grommet on my transom saver tore after 9 years of use. I thought I had to replace the entire transom saver until finding this gem. It was a tight fit, but I used large wood shim and rubber mallet to tap it into place. Some reviews said they had to trim it a little. I was fortunate not having to modify it. Great value and money saver. Heavy duty as well for my 60 hp motor.